Configuring Ospfv3 Maintenance And Diagnosis - Zte ZXR10 T600 User Manual

St- Command
ep
6
ZXR10(config-router)#
7
ZXR10(config-router)#
8
ZXR10(config-router)#
metric <metric-value>][ metric-ttype <
type>][route-maap < name>]
9
ZXR10(config-router)#
Command
show ipv6 ospf <tag>
ZXR10#
show ipv6 ospf database
ZXR10#
show ipv6 ospf interface [<interface-name>]
ZXR10#
show ipv6 ospf neighbor
ZXR10#
show ipv6 ospf route
ZXR10#
show ipv6 ospf topology
ZXR10#
default-metric <metric-value>
passive-interface <ifname>
redistribute < protocol>[
timers spf <delay><holdtime>
Result: The protocol attributes have been configured.
Configuring OSPFv3
Maintenance and Diagnosis
Comparing to RIPng, OSPFv3 is more complicated. A fault phe-
nomena has many fault reasons. Therefore, the maintenance and
diagnosis of OSPFv3 is more difficult.
To maintain and diagnose OSPFv3, use the following commands.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 6 OSPFv3 Configuration
Function
This sets the default metric
value for the OSPFv3 protocol.
The range is from
1–16777214. The default
value is 20.
This disables the interface
where OSPFv3 is enabled to
transmit OSPFv3 packets.
This redistributes routes of
another protocol into OSPFv3
protocol.
This sets interval of OPSFv3
calculating routes.
Function
This shows an OSPFv3 instance.
This shows the database
information about OSPFv3
instance.
This shows the interface
information about OSPFv3
instance.
This shows the neighbor
information about OSPFv3
instance.
This shows the route information
calculated by OSPFv3 instance.
This shows the topology
information about OSPFv3
instance.
39