Siemens Insys 56k Operating Manual page 63

Pocket Modem 56k
S4 Linefeed Character
Linefeed character
S5 Backspace Character
Backspace character
S6* Waiting period for Dial Tone (Before Blind Dialing)
Maximum waiting time for the dialing tone. After the modem went off-hook it
waits 7 seconds for the dialing tone (fixed for approval purposes). If it detects a
dialing tone during this waiting period it will start dialing.
If no dialing tone is detected, it will check if the dialing tone detection has been
activated or if the dial string (Chap. „AT Command Set", command ATD) includes
the parameter W. If dialing tone detection is not active, the modem waits for the
dialing tone. The waiting time is specified in S6.
The value of S6 can be between 4 and 7.
S7* Waiting period for carrier signal
Wait for the carrier frequency from the other modem. The maximum time for the
modem to wait for a response from the other modem is specified in S7. The time
starts running as soon as the modem has finished dialing. The value of S7 can be
between 0 and 180 seconds.
S8*
Dial tone delay
Dial pause time, if a comma is included in the dialing string. If a comma is
included in the dialing string, the modem will wait during the dialing procedure
until the time specified in S8 (in seconds) has run out. The value of S8 can be
between 1 and 7 seconds.
S9* Reaction time Carrier signal
DCD response time for the carrier frequency from the other modem. The DCD
output of the RS232 interface (CT109) of the modem switches to on, when the
carrier frequency from the other modem is detected before the time defined in S9
(in tenth of seconds) runs out. S9 must be smaller than S10.
S10* Time period between lost carrier and hang up
The time which leads to termination after carrier frequency loss. In S10, the time
is specified in tenth of seconds, which the modem awaits to disconnect, if it can't
detect the carrier frequency from the other modem anymore.
S12* Transmission clock of the ESC characters
Minimum pre and post run time and maximum interim time in tenth of seconds
between two characters. This must be observed, if the modem is supposed to
detect an abort sequence (usually +++).
Dezember 05
S- Registry
57