Siemens Insys 56k Operating Manual page 38

AT commands
Command
ATD<n>
C
ONTINUATION
32
Description
Last number re-dialing.
L
Return to the input mode after dialing. Is attached to the end of the
;
dialing string. Causes the modem to return to the input mode after
reaching the character ";" (message: OK) . This enables the input of AT
commands even with a receiver off-hook. The additional AT commands
can follow in the same input line after the ";" or they can be transmitted
to further input lines. The ATH command will abort the connection and
the receiver is hung up.
Dialing the n-th number from the number pool, which was set up with
S=n
the AT&Z command.
Flash. If the character ! is a part of the dialing string, the modem will
!
hang up within the time determined in S29 and then goes off-hook
again.
Suppresses the sending of a ringing tone.
^
The semicolon (;) causes the return to the input mode after dialing.
ATD12345;
Factory setting: Ringing tone is sent for fax operation. No ringing tone
for data operation.
( ) Are ignored: They are just used as an outline.
- Are ignored: They are just used as an outline.
‚ ‚ Space characters are ignored: They are just used as an outline.
Examples:
Dial the phone number 12345
ATD12345
Dial the phone number 12345 with the pulse dialing method
ATDP12345
Dial the phone number 12345 with the tone dialing method
ATDT12345
ATX3D0W12345
For PBXs, which connect to the exchange line using the prefix 0 (or 9):
First, blind dialing is activated with :X3 (see "ATX3" command), to be
able to dial a leading 0 without hearing a dialing tone. After the 0 has
been dialed via :D0 , dialing tone recognition can be switched on again
using the parameter :W . The modem thus waits for the dialing tone and
continues with the rest of the dial-up (via :12345) only after hearing the
dialing tone. Waiting for the dialing tone may be omitted. In this case,
the dialing command is ATX3D012345.
Pocket Modem 56k
Dezember 05