Siemens Insys 56k Operating Manual page 44

AT commands
Command
AT+MR=<n>
AT+MS=<n>
38
Description
Show modulation type
The command "AT+MR" enables the display of the modulation type after the message
CONNECT
Switches the display function off. (default)
AT+MR=0
Switches the display function on. The displayed value applies to the
AT+MR=1
sent data.
Switches the display function on. The displayed value applies to the
AT+MR=2
received data.
If the display function is switched on the modem will display the modulation type and
the line speed after the message CONNECT. After the message CONNECT, the line
„+MCR:" appears, followed by the modulation type (see command AT+MS) and the line
"+MRR:", followed by the line speed.
The AT+MR command is useful for a connection check.
Select modulation type
AT+MS determines the modulation type. The command enables or disables automatic
modulation recognition and defines the highest and lowest possible connection speed.
The command format is AT+MS=Modulation, [Automode], [Send Minbaud,
Maxbaud], [Reception Minbaud, Maxbaud],
Displays the current setting
AT+MS?
Displays a list of possible parameters
AT+MS=?
Default factory setting:
Pocket Modem 56k V92
Pocket Modem 56k
Dezember 05