Siemens Insys 56k Operating Manual page 35

Pocket Modem 56k
Command
AT*A<n>
AT&A<n>
AT%A<n>
AT\B<n>
Dezember 05
Description
Automatic call acceptance on/off
Call acceptance is blocked, irrespective of S0
AT*A0
Call acceptance according to S0 (default)
AT*A1
Note: see also S-Registry 36, bit 7
Selective Call Answer On or Off
To evaluate selective call answer, the phone number must be transmitted (CLIP). The
following countries support the "CLIP" function:
Australia, Belgium, China, Denmark, Germany, Finland, Great Britain, Hong Kong, India,
Ireland, Iceland, Italy, Canada, Korea, New Zealand, The Netherlands, Norway, Austria,
Sweden, Singapore, Spain, Taiwan, USA.
Switches the selective call answer on
AT&A1
Switches the selective call answer off (default)
AT&A0
The AT&A setting is saved in AT&W .
Send alarm text manually
Manual triggering of the message. A response regarding the success or failure "OK" or
"ERROR" in sending the message.
Note: see also AT*V<n>
Send "break" to the other modem
For connections that were not error corrected the modem sends a break signal to the
other modem. The length of the signal is: the specified parameter times 1/10 of a
second.
For error corrected connections, the modem sends a break signal according to the active
error correction protocol without considering a parameter specification.
If no connection is established or if a fax connection is active, an error message is
displayed.
1/10 second break signal
AT\B1
2/10 second break signal
AT\B2
3/10 second break signal
AT\B3
4/10 second break signal
AT\B4
5/10 second break signal
AT\B5
6/10 second break signal
AT\B6
7/10 second break signal
AT\B7
8/10 second break signal
AT\B8
9/10 second break signal
AT\B9
AT commands
29