Installation Instructions - Siemens Insys 56k Operating Manual

Mounting
4.3

Installation Instructions

Please observe our safety instructions.
1 Switch on power supply
2 Connection with the PC
Connect the 9-pin jack at the modem with the serial
interface of your computer.
3 Driver Installation
If you use a terminal program or the HSComm program, the
installation of a driver is not necessary. If you use another
application, a driver may be necessary. Please find our
current drivers at http://www.insys-tec.de or install the
windows standard modem 336.
4 Modem communication
Now, start your communication program on the PC and set it
to the used COM interface. The modem will automatically
adjust to the baud rate of your PC.
5 Communication Control via a Terminal Program
Perform a short test using your terminal program
(TeraTermPro, ProcommPlus).
Check if the installation was successful
Enter the command and push the "Enter" key.
When the message appears on your monitor, the device
has been successfully installed.
6 Connection with the telephone network
Plug the supplied phone cord into the jack on the rear of
the modem. The plug of the cable must lock in.
The other end of the phone cord is plugged into the
telephone outlet. When modems are connected to older
phone outlets, an adapter or a multiple TAE/N outlet may
be necessary.
7 Check the connection between two modems
Enter the command and push the "Enter" key
Attention: For PBXs that require a code number to
The modem will be connect.
4
establish a connection – the code number
is usually "0"- a different command must
be used.
Pocket Modem 56k
Power LED on
AT
LED RXTX on
OK
ATDT 0101901929
ATX3DT 0101901929
LED OH on
Connect...
LED DCD on
Dezember 05