Samsung SCX-6345N/XAA Service Manual page 111

Display
DHCP server error. An
Auto IP address has
been established.
DHCP server error. An
Auto IP is not working.
Drum Cartridge Initializi
Drum Communication
Error
Drum Warning
Duplex Jam 0
Duplex Jam 1
Duplex Jam 2
Ejector Fault
Fax Memory is empty.
Fax Memory is low.
Feed Jam at MP Tray
Feed Jam at Tray 1
Feed Jam at Tray 2
Feed Jam at Tray 3
Feed Jam at Tray 4
Finisher Duplex Jam
Finisher Interface Error
Finisher Jam 0
Finisher Jam 1
Finisher Jam 2
Finisher Stacker Full
Front Jogger Fault
Fuser error
Fuser High Error
Fuser Low Error
Fuser unit error
Samsung Electronics
Meaning
DHCP server does not work. The machine
is working with the setting IP by auto IP
setting function.
The DHCP server does not work, and the
auto IP setting is failed.
It is the mixing time when installing the
new drum cartridge up to 180 sec.
Communication between the drum
cartridge and the machine has failed
The drum cartridge is invalid.
The drum cartridge is near the end of its
life.
Paper has jammed during duplex printing.
Paper has jammed during duplex printing.
Paper has jammed during duplex printing.
Ejector unit is not operating.
There is no more available fax
memory. No more fax data can be
received.
Available fax memory is now 1MB.
Paper Misfed from multi-purpose tray
Paper misfed from tray
Paper jammed in the stacker.
Communication error has occurred
between the stacker and the machine.
Paper jammed in the stacker.
Paper jammed in the stacker exit part.
The stacker is full of printouts.
Front Jogger is not operating.
There is a problem in the fuser unit.
Alignment & Adjustments
Suggested solutions
Set the network setting again or assign a
new static IP address.
Set the network setting again or input the
new static IP addre.
Wait about 180 seconds until the
machine is ready.
Reinstall the drum cartridge. If the prob-
lem persists, replace it.
Ensure a replacement cartridge in stock.
Clear the jam.
Clear the jam.
Clear the jam.
Remove paper from the output tray
(finisher). If this error message shows on
the screen again, cycle power. If the
problem persists, call for service.
Delete the received fax data in the
memory. Call for service to delete fax
memory.
Delete the received fax data in the
memory to secure memory.
Clear the jam.
Clear the jam.
Open the stacker door and remove
jammed paper by lowering guide 1a or 1b.
Turn the machine off and turn it on again.
Open the stacker door and remove
jammed paper by lowering guide 1a or 1b.
Pull jammed paper from the stacker exit.
Remove printouts from the stacker.
Open the finisher door and clear any
jammed paper (if there is). If this error
message shows on the screen again,
cycle power.
Unplug the power cord and plug it back
in.
Service Manual
4-63