Commands For Operating The Efoy Unit - EFOY 600 User Manual

5. Data Port Commands
Command
BUTTON [1/0 / AUTO]
LANGUAGE [? / language]
5.4

Commands for Operating the EFOY Unit

Output in the terminal program
This allows you to reproduce the functions governed by
buttons on the remote control. You must always
indicate a parameter corresponding to the button to be
"pushed".
Button
auto
Example:
SFC>BUTTON AUTO↵
OK
SFC>BUTTON↵
no valid parameter
SFC>BUTTON 1/0↵
OK
SFC>
In this example, the EFOY unit began in the automatic
mode. No parameter was indicated with the second
command. The response was therefore an error
message. The third command switches between the ON
(1) and OFF (0) status. In the case at hand, (previous
status is AUTO), the EFOY unit switches to OFF.
Changes the language on the remote control or
displays the language currently selected.
If the command is transmitted without parameters, the
EFOY unit replies with the language currently selected.
If a new language is transmitted as a parameter, it
registers as a new language. In order to display all
available languages, it is necessary to add the
parameter ? to the command.
Example:
25
Parameter
AUTO
On/Off 1/0