EFOY 600 User Manual page 10

4. Configuring the Data Port
If you have a serial port, please follow the instructions
contained in Point 4.
If you do not have an RS232 serial port, please use a
USB adapter on RS232.
USB adapters are usually installed on the computer.
Follow the manufacturer's installation directions.
Then connect the interface adapter to the USB adapter.
Use a free USB port to connect the adapter to your
computer.
4. Connect the RJ45 plug on the data line to the data
interface of your EFOY fuel cell.
5. Check the connection between computer and EFOY
fuel cell by selecting the terminal program on your
computer.
If the prompt
SFC>
appears after you press the Enter key
then the connection to the EFOY fuel cell has been
established.
If you have not yet set up the terminal program, follow
the instructions in Chapter 4.3 Setting Up the Terminal
Program.
10