Saf-H/Saf Circuit Board And L Block - Hitachi DZ-MV580A Service Manual

Disassembly and Reassembly > Disassembly

(3) SAF-H/SAF Circuit Board and L Block

1) Open the LCD monitor (c).
2) Remove three screws [A], two screws [N] and three screws [C].
3) Close the LCD monitor and open the L block (b) from the rear in the direction of the arrow:
Be careful not to damage the SAF-H/SAF circuit board (a) or flat cable between L block and R
block (d).
4) Remove the SAF-H/SAF circuit board. The SAF-H/SAF circuit board is a film-like board:
Do not bend or fold it.
5) Disconnect the flat cable between L and R blocks. Disconnect the flat cable between L and R
blocks: Do not forcibly pull out the flat cable from connectors at this time.
6) Remove the L block from R block (d) in the direction of the arrow.
(a) SAF-H/SAF circuit board
(b) L block
(c) LCD monitor
(d) R block
(b)
(c)
1)
(1)
(2)
2) [C]
2) [A]
5)
3)
2) [C]
2) [N]
Fig. 5-3-3 Right side
2) [A]
Fig. 5-3-4 Bottom Side
(1) Unlock
(2) Pull
4)
(a)
6)
Pattern no,
printed side
2) [N]
[A] M1.7x4 (Black)
[N] M1.7x4 (Silver)
[C] M1.7x4 (Silver)
5 - 4
(d)
2) [A]