Hitachi DZ-MV580A Service Manual page 38

Troubleshooting > Messages and Troubleshooting
Message
Data error in all image file.
Repair all data now?
YES NO
DISC ××××
(4-digit alpha-numerals
showing the code of trouble
will appear in ××××.)
DISC ACCESS
DISC ALMOST FULL
Disc error
Disc error has occurred.
Finalizing is not complete.
Cause/condition for
message to appear
Appears if writing to file cannot be
completed normally because power was
turned off by mistake during video
recording or editing, and it is recognized
that the video file must be totally
repaired.
Also appears when condensation occurs
on lens or drive of DZ-MV580A/MV550A.
Condensation will occur when the DZ-
MV580A/MV550A is moved form a cold
place to a warm place.
Appears if the self-diagnosis function in
DZ-MV580A/MV550A detects a serious
problem.
This message appears during normal
operation process, when DZ-MV580A/
MV550A checks whether a proper disc
has been loaded or not. It is displayed for
a longer time period when the date has
changed.
This message appears during normal
operation process, when the recorded
images are being stored on disc.
Appears if the remaining video
recordable time on disc is less than 10
minutes, or the remaining number of
recordable photos is less than 10.
Appears when the disc has been edited
on a device other than DZ-MV580A/
MV550A, and mismatch has occurred in
recorded data.
Also appears when reading or writing
from/to recorded file cannot be performed
because the disc is dirty.
Appears when the disc could not be
finalized because it was dirty.
Appears if accident, such as power off,
has occurred during finalizing.
If the message still appears even when
the disc has been cleaned and finalized
again and again, the disc may be
defective.
4 - 15
Troubleshooting
Choose "YES" and designate total
repair (automatic repair) of video file.
Choosing "NO" will display a
message for verifying initialization.
[Refer to *3 page 4-14]
Do not execute repair, but set the
power switch to "POWER OFF" with
the disc loaded, and then leave the
DZ-MV580A/MV550A in a dry place
until condensation disappears
(usually 1-2 hours).
Take note of the 4-digit alpha-
numerals in ××××, and refer to "4-5
Self-Diagnosis Function and
Troubelshooting".
Operate DZ-MV580A/MV550A after
the message disappears.
Operate DZ-MV580A/MV550A after
the message disappears.
Delete unnecessary scenes, or replace
the disc.
Format the disc (deleting all recorded
data), or replace the disc.
Clean the disc, or replace it.
[Refer to page 4-14]
Clean the disc, or replace it.
[Refer to page 4-14]
Set the power switch to "POWER
OFF" and reconnect the AC adapter/
charger; then set the power switch to
"VIDEO" and start finalizing again.
Or press the DISC EJECT button,
reload the disc, and then execute
finalizing.
Replace the disc.