Hitachi DZ-MV580A Service Manual page 40

Troubleshooting > Messages and Troubleshooting
Message
Disc is not formatted.
If it formats, it becomes
possible to use for camera.
However, when you record
from PC connection
terminal, please do not
format.
Format the disc now?
YES NO
Disc overheat.
Please retry later.
DPOF is not set to scene
DPOF scenes over limit.
Cannot set DPOF scenes.
DVD-R Disc, Video mode
cannot be changed.
END OF DISC
End scene cannot be divided.
Error has occurred.
Error code No. ××××
Please read the manual.
(4-digit alpha-numerals
showing the code of trouble
will appear in ××××.)
*4: The purpose of formatting DVD-R disc on DZ-MV580A/MV550A is to write to disc a program exclusively
for camera recording that is necessary to record images shot by camera in real time (increasing the
response from disc). When recording images that were edited using PC on DVD-R disc via the PC
connection terminal, do not format the disc: The program used exclusively for camera recording will
disable normal recording.
Cause/condition for
message to appear
Appears when a brand-new DVD-R disc
was loaded.
Appears when the temperature inside
DZ-MV580A/MV550A, or the
temperature of disc, is too high, and
normal operation cannot be executed.
Appears if "Slide Show: DPOF" is
specified when a card for which DPOF
has not been set is loaded.
Appears when the number of settable
scenes for DPOF has exceeded 999.
Appears if an attempt is made to change
the Video recording mode of a recorded
DVD-R disc. Once even one scene is
recorded on a DVD-R disc which has
been initialized, the originally
designated Video recording mode is
specified to be maintained until the final
recording on the disc.
Also appears after the DVD-R disc has
been initialized.
Appears if the disc recordable capacity
has reached the limit during recording.
Appears when the last image of scene
was selected to divide the scene: The
specifications state that dividing a scene
at its end is not possible.
Appears if the self-diagnosis function of
DZ-MV580A/MV550A has detected a
serious problem when power was turned
on, or the same trouble occurred three
consecutive times in modes other than
recording.
4 - 17
Troubleshooting
When recording on DZ-MV580A/
MV550A, choose "YES" and designate
it. When recording video edited on PC
connected via the PC connection
terminal, choose "NO" and designate
it.
*4
Set the power switch to "POWER
OFF" with the disc loaded, and then
leave the DZ-MV580A/MV550A in a
well-ventilated place until the inside
temperature decreases.
Specify "Slide Show: All", or do not
try slide show.
Release unnecessary DOPF setting
on photos when newly setting DPOF.
Stop trying to change the Video
recording mode, or replace the disc.
Operate DZ-MV580A/MV550A after
the message disappears.
Replace the disc.
Stop trying to divide a scene.
Take note of the 4-digit alpha-
numerals in ××××, and refer to "4-5
Self-Diagnosis Function and
Remedy".