Table of Contents
Advertisement
Disassembly and Reassembly > Disassembly
(3) Eyecup, SAF Circuit Board, and L Block (Figs. 5-3-3, 5-3-4)
Eyecup (a)
1) Pull the EVF unit
2) Remove the eyecup in the direction of the arrow.
SAF Circuit Board (b) and L Block (c)
3) Open the LCD monitor.
4) Remove screw [A] from the top of L block.
5) Remove two screws [A] from the battery pack attachment platform.
6) Remove screw [A] from the rear of L block.
7) Remove two screws [B] from both sides of PC connection terminal.
8) Remove two screws [A] from the bottom of L block.
9) Open the L block from the rear in the direction of the arrow: Be careful not to damage the SAF
circuit board and flat cable (e) between L block and R block (d).
10) Disconnect the SAF circuit board between L and R blocks. The SAF circuit board is a film-like
board: Do not bend or fold it.
11) Disconnect the flat cable between L and R blocks.
12) Remove the L block from R block in the direction of the arrow.
11-1
11-2
11
(c)
(e)
3
7 [B]
8 [A]
Fig. 5-3-3 Eyecup, SAF Circuit Board, and L Block
(a) Eyecup
(b) SAF Circuit Board
(c) L Block
(d) R Block
(e) Flat Cable
4 [A]
1
6 [A]
(b)
10
12
PATTERN No.
9
PRINTED SIDE
5 - 4
(d)
(a)
2
5 [A]
5 [A]
Fig. 5-3-4 Eyecup, SAF Circuit Board,
and L Block
[A] M1.7×4 (Black)
[B] M1.7×4 (Silver)
8 [A]
Advertisement
Table of Contents
