Swl3-H/Swl3 Circuit Board - Hitachi DZ-MV580A Service Manual

Disassembly and Reassembly > Disassembly

(7) SWL3-H/SWL3 Circuit Board

1) Unplug the connector. Be sure to hold the connector using tweezers, etc. when unplugging it.
Pulling the cable when unplugging the connector could cause wire disconnection.
2) Remove one screw [D].
Procedure and caution for reassembly
1) Insert the switch knob (b) on SWL3-H/SWL3 circuit board between the knobs (c) of L cover.
2) Pass the cable to be connected to the SWL3-H/SWL3 circuit board through cable holder (e) under
ground plate (d) and wire retaining slit (f) as shown in the figure, so that the cable is laid out
along the side case L and L cover as far as possible.
(a) SWL3-H/SWL3 circuit board
(b) Switch knob
(c) Knobs of L cover
(d) Ground plate
(e) Cable Holder
(f) Wire retaining slit
2) [D]
(a)
[D] M1.7x4 (Black)
(b)
(c)
Fig. 5-3-8
5 - 6
1)
(a)
(e)
(f)
(d)