Displaying The Acls; Displaying Ipv4 Acls; Displaying Ip Acl Port Assignments; Figure 204: Show Access-List Command - Allied Telesis AT-9000 Series User Manual

Chapter 75: Advanced Access Control Lists (ACLs)

Displaying the ACLs

Displaying IPv4
ACLs
IP access-list 3000
IP access-list 3104
MAC access-list 4400
IP access-list icmppermit
IP access-list denytcp
Total number of access-lists= 5
Displaying IP
ACL Port
Assignments
1270
There are several ways of displaying information about ACLs on the
switch. You can use one command to display a list the Numbered IP IP
ACLs. In addition, you can display the port assignments of all the ACLs
and the ACLs assigned to VTY lines. See the following:
"Displaying IPv4 ACLs" on page 1270

"Displaying IP ACL Port Assignments" on page 1270

"Displaying ACLs Assigned to VTY Lines" on page 1271

To display the Numbered IPv4 and Named IPv4 ACLs, use the SHOW
ACCESS-LIST command in the Privileged Exec mode. Here is the
command syntax followed by an example display.
awplus# show access-list
permit icmp any any
deny 149.87.201.1 mask 255.255.255.0 any
permit any any
ICMP permit an any time-range daily
TCP deny 149.55.65.0 mask 255.255.255.0 any time-range NONE
Figure 204. SHOW ACCESS-LIST Command
As you can see from the example, the SHOW ACCESS-LIST command
does not display which, if any, ports the ACLs are assigned to. To display
that information, use the SHOW INTERFACE ACCESS-GROUP
command. See "Displaying IP ACL Port Assignments," next.
To display the IP ACL port assignments for both IPv4 and IPv6 ACLs, use
the SHOW INTERFACE ACCESS-GROUP command in the Privileged
Exec mode. Here is the format of the command:
show interface
The following example displays the ACLs assigned to ports 1 to 5:
port
access-group