Table of Contents
Advertisement
Software
Each VSN870 shipped by Datapath is custom built. If cards are not pre-installed then installation of the
software is required. For information on software installation consult the relevant user manual contained
on the installation CD.
If you have ordered Datapath Wall Control-red software and this has been installed prior to shipment,
please ensure the Wall Control-red hardware USB key is installed before system boot up.
To install the Wall Control-red hardware USB key, remove from its packaging and insert it into a vacant
USB port as shown below:
Fig.4
8
Advertisement
Table of Contents
Need help?
Do you have a question about the VSN870 and is the answer not in the manual?
Questions and answers