Datapath Fx4 Quick Start Manual
  1. Manuals
  2. Brands
  3. Datapath Manuals
  4. Controller
  5. Fx4
  6. Quick start manual

Datapath Fx4 Quick Start Manual

Multi display controller
Hide thumbs Also See for Fx4:
1
2
3
4
5
6

Advertisement

Table of Contents

See also: User Manual
Datapath Limited
Bemrose House
Bemrose Park
Wayzgoose Drive
Derby, DE21 6XQ
UK
Tel: +44 (0) 13332 294441
Email: sales@datapath.co.uk
www.datapath.co.uk
Datapath North America
2550 Blvd of the Generals
Suite 30
Norristown, PA 19403
U.S.A
Tel: +1 484 679 1553
sales@datapath.co.uk
Product
Fx4 Display Controller Quick Start Guide
Classification
Released
Version Number
1.1.0
Multi Display Controller
Quick Start Guide
Thank you for purchasing the Datapath Fx4 multi display controller.
The aim of this document is to quickly guide you through the process
of initial setup. For detailed instructions consult the Fx4 User Guide
which can be found on the Software Installation CD.
www.datapath.co.uk | sales@datapath.co.uk | +44 (0) 1332 294441

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Fx4 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Datapath Fx4

Summary of Contents for Datapath Fx4

  • Page 1 The aim of this document is to quickly guide you through the process Version Number 1.1.0 of initial setup. For detailed instructions consult the Fx4 User Guide which can be found on the Software Installation CD. www.datapath.co.uk | sales@datapath.co.uk | +44 (0) 1332 294441...
  • Page 2 If any of the items are missing, please contact Datapath for further instructions. A full list of product compliance certifications can be found in the product User Guide The Fx4 is not supplied with input and output cables therefore please ensure you have on the Software Installation CD supplied with the system.

  • Page 3: Copyright Statement

    All registered Connect your input source to one of the 3 input connectors on the rear of the Fx4. You trademarks used within this documentation are acknowledged by Datapath Limited.

  • Page 4: Step 5 Connecting To A Pc

    Wall Designer application. Connect Mains Cable Switch on When the power is switched on the Fx4 will boot and the LEDs on the front panel will flash for up to 15 seconds. Should the LED’s continue to flash see the troubleshooting section.

  • Page 5: Step 9 Multiple Devices

    STEP 6 CONFIGURE VIA A NETWORK STEP 9 MULTIPLE DEVICES The Fx4 has dual ethernet ports to allow users to add the device to their network. Only one Fx4 Where more than four outputs are required, (the example below shows eight) the Auto Config in any chain requires connection to the physical LAN as ethernet loop through is supported on Fx4 function will determine the most logical way to connect all devices.

  • Page 6: Step 7 Wall Designer

    Select the monitor be displayed on your by clicking on manufacturer from the drop monitors. Click on the Auto-configure Fx4. Once down list on the left, then Create button and select a you are satisfied with the select the model.

Table of Contents