Power Connections - Crest Audio GT Owner's Manual

C S
ENTURY ERIES

Power Connections

The connections to and from the power supply vary depending
on your specific configuration. Before setting up the console,
always check to make sure the AC voltage marked on the
power supply agrees with the local supply. Always connect the
console to the power supply before switching on the power
supply. Do not run the power supply if it is not connected to
the console.
Multiple power supplies can be daisy-chained to provide fail-
safe protection in the event of a supply failure. When two or
more supplies are used, both power supplies run all the time. In
the event of supply failure, the remaining power supply(s) will
take over the entire load.
POWER OUT
2 1
AVIS : RISQUE DE CHOC ÉLECTRIQUE—NE PAS OUVRIR
4 3
5
WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT
7 6
ATTENTION! POUR ÉVITER LE RISQUE D'INCENDIE OU DE CHOC
ÉLECTRIQUE, NE PLACEZ PAS CET APPAREIL SOUS LA PLUIE OU Á
Pin 1 +24V
Pin 2 +20V
Pin 3 Analog
POWER OUT
Pin 4 Analog
Pin 5 Digital
Pin 6 +48V
Pin 7 -20V
Interface Cable
POWER OUT
2 1
AVIS : RISQUE DE CHOC ÉLECTRIQUE—NE PAS OUVRIR
5 4 3
WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT
7 6
ATTENTION! POUR ÉVITER LE RISQUE D'INCENDIE OU DE CHOC
ÉLECTRIQUE, NE PLACEZ PAS CET APPAREIL SOUS LA PLUIE OU Á
Pin 1 +24V
Pin 2 +20V
Pin 3 Analog POWER OUT
Pin 4 Analog
Pin 5 Digital
Pin 6 +48V
Pin 7 -20V
To Console
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
Model XCVA04
S/N
L'HUMIDITÉ
20V @ 4
+ 24V @ 4
Designed & manufactured in the USA by:
+ 48V @ 1
+ 24V @ 6
20V @ 6
A division of Crest Audio Inc.
100 Eisenhower Dr. Model XCVA06
Paramus, New Jersey 07652 USA
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
Model XCVA04
S/N
L'HUMIDITÉ
20V @ 4
+ 24V @ 4
Designed & manufactured in the USA by:
+ 48V @ 1
+ 24V @ 6
20V @ 6
A division of Crest Audio Inc.
100 Eisenhower Dr.
Model XCVA06
Paramus, New Jersey 07652 USA
NOTE: Although both of the multi-pin connectors on the back
of the power supply are labeled "POWER OUT", it is neces-
sary (and acceptable) to link two power supplies together as
shown in the diagram below.
ADDITIONAL NOTE: The multi-conductor cable used for
power supply-to-power supply connection is different than that
used for a conventional power supply-to-console connection,
and must be specified when the second power supply is
ordered.
Ground Link
CONSOLE CHASSIS
G R O U N D
GROUND
MAXIMUM AC IN:
XCVA04: 415 WATTS
XCVA06: 825 WATTS
To AC Mains
CONSOLE
CHASSIS
G R O U N D GROUND
MAXIMUM AC IN:
XCVA04: 415 WATTS
XCVA06: 825 WATTS
To AC Mains
SP / TC / GT
P 5
AGE