System Check - SAGEMCOM RCI88-320 User Manual

7.8 System Check

The information contained in this menu may be requested if you contact your supplier or another technical
service.
You will find here information about the receiver and the embedded software, smartcard information and a
system diagnostic utility.
To return to the previous screen and save your changes, use the ZURÜCK
To exit the menu screen, press the MENÜ
7.8.1 Device Information
This menu provides information on the receiver, the embedded software and last updates, as well as the
remaining capacity of the receiver's hard disk.
1. Press the MENÜ
2. Select SETTINGS with
3. Select SYSTEM CHECK with
4. Select DEVICE INFO with
7.8.2 Smartcard Information
This menu provides information on your smartcard. Make sure the smartcard is inserted into the receiver
to retrieve and display this information.
1. Press the MENÜ
2. Select SETTINGS with
3. Select SYSTEM CHECK with
4. Select SMARTCARD with
7.8.3 TV Signal
This menu provides information on the cable network, and lets you find out the signal level on different
channel frequencies.
1. Press the MENÜ
2. Select SETTINGS with
3. Select SYSTEM CHECK with
4. Select TV SIGNAL with
The following Network information is displayed:
• Last Network Scan: date of the last scan
• TV/Radio Channels: number of TV and Radio channels installed
• Signal level: shows, for each tuner, the signal quality of the current channel
• BER: shows, for each tuner, the Bit Error Rate of the current channel
• Network info: cable network name
key.
or , and press OK
or , and press OK
or .
key.
or , and press OK
or , and press OK
or .
key.
or , and press OK
or , and press OK
or .
60
or EXIT key.
.
or the right key.
.
or the right key.
.
or the right key.
or the left key.