Jenn-Air SEG196 Use And Care Manual page 16

1. Be sure control knobs are turned off.
2. If the grill burner and grill grates are in place, remove before installing a surface
burner module. Clean burner basin of any grease accumulation.(See page 21
for cleaning recommendations.)
3. Position the burner assembly with the mixer tube openings toward the orifices.
Slide the burner assembly towardthe orifices untilopening for igniter isover the
igniter. Lower into place until side openings are resting on the burner supports
and igniter is centered between the two flash tubes.
4. install the aeration tray by inserting the prong at the end of the pan Into the
opening in the end of the burner basin, Lower the oppositeend into the range
top. Note: Before first use, read the Surface Burner Grates Care instructions
found on p. 22.
1. Control knobs should be in the OFF position and the range top should be cool.
2. Remove the aeration tray by lifting up the front end on the right side (back end
on the left side) until the top clears the opening of the range top by about 5
inches.
3. Hold aeration tray by the sides and slide away to remove the prong from the
opening and clear the surface burners.
4. Lift up on the sides of the surface burner assembly bracket about 2 inches. Slide
away from the orifices.
5. A storage tray, Model AG350, is available and can be used for stodng a surface
burner module.
NOTE: Optional surface burner assembly, Model AG20O, can replace the gdll
burner assembly, Model AG200 air shutters have been adjusted for
compatibility on the left side.
NOTE: Do not disassemble the surface burner assembly.
16