Quickie Puma 20 Technical Manual page 188

188 | Trouble shooting
Sub
Flash Fault
code
Code source
(HHP)
09, 10 DX BUS All
All
Internal fault All
other
DX2 System condition indications
Condition
CLAM is enabled
DX System Faults Master Remote in Fault State
DX2-ACT detects CAN Fault
Module ID Collision
(2 modules with same ID)
ACT Module Missing "Slow1/Slow2"
Actuator System ACT Module Missing "Stop"
Configuration Faults
Actuator Module Local Fault
Actuator Module Local Fault
ACI "Flash Code 2"
ACI "Stop (Drive Inhibit)"
ACI "System Slowdown"
ACI "Slow" function
active ACI "Local Slow"
ACI in Speed Pot or Speed Limit
mode, with outputs less than 100%
*The REM550 responds to a missing DX2 actuator system if the following parameters are set:
Parameter
Actuator System Type
Actuator System Is Critical
Actuator System Missing
Meaning
DX BUS hardware fault
• Check DX BUS cables
• Turn the system off and on several times. Make sure to wait 10
seconds before you turn the system on again.
• If all DX BUS connections are OK and turning the system off and on does not help, contact
the Service Department of Sunrise Medical HCM
Contact the Service Department of Sunrise Medical HCM
Required Value
DX2 Actuator System
Yes
"Stop Drive" or "Slowdown Drive", as desired.
DX2-ACT DX2-REM550
indication indication (DX2)
None, but ACT will
not None
drive actuators
FC according to
FC6
fault
FC6/9/10, FC according to
depending fault detected by
on actual fault Remote
FC6, No DX BUS Actuator system will
communication be "missing"*
None FC2, Drive inhibit*
None FC2*
FC2 on remaining
Drive Inhibit
ACT Module
See DX2-ACT Flash
None
Code List
FC2 FC2
FC2 Drive inhibit
FC2 FC2
Reduced speed on
FC2
Speedometer
Reduced speed on
FC2
Speedometer
Puma 20/40
DX-REMG90
indication (DX)
None
FC according to
fault
FC according to
fault detected by
Remote
None
Not detected
Not detected
Drive Inhibit
None
FC2
Drive inhibit
FC2
None
None