Table of Contents
Advertisement
HTC GL 270 HD
3.2
Description of controls - Control panel
The picture below shows the machine's control panel:
Figure 3-3. Control Panel
1.
2.
3.
2.0
O/I- Start/stop the machine. Turn the knob to "I" to start the machine. Hold the
knob in the start position "I" for ca 1-2 seconds.
Unloaded start is recommended, which can be done by lifting the grinding
head from the surface.
Turn the knob to "O" to switch off the machine.
Warning lamp start capacitor protection - The lamp lights when the start
knob as been in the start position too long, or in the case of repeat short
attempts to start.. Normally, the lamp goes out automatically after 2 minutes.
EM-Stop - Emergency stop switch: In an emergency, press the switch to cut
the power to the machine. Reset the emergency stop switch by turning it 45°
clockwise.
Machine description
11
Advertisement
Table of Contents
