Table of Contents
Advertisement
Operation
5.
Slowly pull the chassis back from the grinding head.
4.6.2
Attach the grinding head to the chassis
1.
Push the chassis's fastener into the quick release and make sure that the red locking
hooks drop down, so the safety pins can be put in place.
2.
Replace the vacuum hose and connect the quick release coupling to the motor. The
machine is now ready to use.
4.7
Operation
The machine's functions can be controlled using the controls on the control panel,
see Figure 3-3, page 11.
4.7.1
Starting the machine
1.
Connect cable to mains voltage.
2.
Reset the emergency stop switch. See Emergency stop switch, page 18.
3.
Turn the Power knob to "I" to activate the electronics. Hold the knob in the start
position "I" for ca 1-2 seconds.
4.
Turn the Power knob to Off ("O") to switch off the machine.
4.7.2
Emergency stop switch
The emergency stop switch, (EM-Stop) must only be used in an emergency, because it
shortens the service life of the machine's electrical components.
When the switch is pressed, all electrically-powered equipment on the machine are
turned off.
Note!
Do not use the emergency stop switch to stop the machine, except in
emergencies. As long as the emergency stop switch is pressed in, the machine
cannot be started. Reset by turning the switch clockwise. The machine can then
be restarted.
4.8
Making operation easier
In order to keep the suction hose for the dust extractor and the power cable out of the
working area and/or path of the machine, the hose and cable can be arranged as shown
in the picture below.
18
HTC GL 270 HD
2.0
Advertisement
Table of Contents
