Description Of Controls - Control Panel - HTC 650 HDX User Manual

Machine Description
3.2. Description of Controls – Control
Panel
The picture below shows the machine's control panel:
Figure 3-3 Control panel
12
Power - Standby indicator: Indicates that
1.
the machine's functions have been activated.
Shines with a green light when the start key
(7) is turned to the right "On".
Overload- Overload indicator: Lights up to
2.
indicate that the machine is using too much
power. If this is ignored, the power supply to
the motor will be interrupted and an error code
generated.
3. Reset - Resetting the electronics: If the
machine experiences an error, it can be reset
by pressing and holding the button in for
two seconds. Any error code is shown on the
display in the electrical cabinet, see Figure
3-2 on page 11.
Speed- Rotational speed: Regulates the
4.
rotational speed of the machine's grinding
discs.
5. Start/Stop - Start/stop the grinding discs'
rotation. Turn the knob to "Start" to start the
rotation, turn the knob to "Stop" to switch off
the rotation.
6. EM-Stop - Emergency stop switch: In an
emergency, press the switch to cut the power
to the machine.
HTC 650 HDX
1.0