HTC GL 270 HD User Manual page 15

HTC GL 270 HD
Note!
The machine may only be used to grind, strip and clean floor coverings and
other materials that are stated in this manual or materials that are recommended
by HTC.
Note!
Only original tools and spare parts from HTC may be used for the machine.
Otherwise, neither the CE marking nor the warranty will be valid.
Note!
For the CE marking to be valid, the instructions in this manual must be
followed.
Note!
The machine may only be lifted using the lifting eye on the chassis in
accordance with the relevant instructions.
Note!
Make sure that the floating cover can move freely within its movement margins
and that the cover rests on the floor before starting the machine.
Note!
The machine should be stored in a dry, warm (plus degrees) location when not
in use. If the machine is stored in a cold area (below zero), it must be kept in a
warm area (above zero) for at least two hours before use.
Note!
When dry grinding, a suitable dust extractor should be used. For available
models of dust extractors, go to HTC's website
more information.
Note!
The dust extractor's suction hose must be connected to the appropriate socket
on the machine. Adjust the dust extractor to match the grinder's capacity.
Note!
Do not use the emergency stop switch to stop the machine, except in
emergencies. As long as the emergency stop switch is pressed in, the machine
cannot be started. Reset by turning the switch 45° clockwise so that it pops out
again. The machine can then be restarted.
Note!
Check that all the parts are correctly attached and that all the screws are
tightened properly before the machine is started.
2.0
www.htc-floorsystems.com
Safety
for
7