Control Description - Control Panel; Standby Indicator - Power; Overload Indicator; Resetting The Electronics - Reset - HTC 650 HDX Manual

Control Description - Control Panel

1. Standby indicator - Power:

This lamp indicates that the machine is in standby mode
with its systems activated. The position of the key in the
ignition switch determines whether the grinder is shut off
or in standby mode and ready for use.

2. Overload indicator:

This lamp lights when the grinder is using too much
power when processing. If you ignore the lamp, the
machine will cut the power supply to the motor and an
error code will be generated.

3. Resetting the electronics - Reset:

If the machine has any kind of error, it may need to be
reset. Hold the button down for two seconds to reset
the electronics. Any error codes can be viewed on the
frequency control display inside the electrical cabinet. A
description of the error codes is on Pages 7-3.
4. Adjusting the rotational speed of the grinding
head - Speed (Grinding Head Speed):
Use this knob to set the rotation speed for the grinding
head. The speed can be set before starting the grinding
head when starting at low speed, for example.
5. Start/Stop of the rotation of the grinding head -
Start/Stop (Grinding Head):
Use this switch to start or stop the grinding head and
grinding disk rotation.

6. Emergency Stop - EM-Stop:

Only use the Emergency Stop switch in emergencies
when immediate shutdown of the grinder is necessary.

7. Ignition switch (Standby):

Use the key to activate the grinder's electrical system.
The machine assumes standby mode and is ready for
use.
5