Teo 7810 Network Administration Manual page 13

Parameter
UpdateSrvr
ConfigFile
L2Q
L2QVLAN
VoicePri
SignalPri
13-280132 Rev. Q
DHCP Option 125
Data / Description
Update server protocol, IP address or fully qualified
domain name, and port number. This configures the
same parameter as XML tag <update_server>.
Refer to the DHCP Option 66 table (page 9) for allowed
values.
NOTE: To avoid conflicts, do not enter update server
parameters in DHCP Option 66 if it is set here.
The naming scheme for custom XML configuration
files (not used with the Teo protocol). This configures
the same parameter as XML tag
<config_file_name_base>.
MAC – Ethernet MAC address (default)
LINE – phone line ID
Enables VLAN / Ethernet Layer 2 802.1Q support. This
configures the same parameter as XML tags
<vlan><enable>.
1 – VLAN enabled
0 – VLAN disabled (default)
NOTE: To avoid conflicts, do not enter VLAN data in
DHCP Option 242 if it is set here.
Phone VLAN ID.
A value of 0 (zero) indicates that the phone does not
belong to any VLAN; in this case, the 802.1Q tag
specifies only a priority and is referred to as a priority
tag. This configures the same parameter as XML tags
<vlan><id>.
0, 2 – 4094, default value = 1111
NOTE: To avoid conflicts, do not enter VLAN data in
DHCP Option 242 if it is set here.
802.1Q Voice Priority Code Point. This configures the
same parameter as XML tags <vlan><voice_pri>.
0 – 7, default value = 6
802.1Q Signaling Priority Code Point. This configures
the same parameter as XML tags <vlan><signal_pri>.
0 – 7, default value = 6
Network Setup
Page 13