Enhanced Stacking - Allied Telesis AT-8024 Installation Manual

Telnet Application Protocol
Using the Telnet application protocol is another way for you to manage
the switch remotely from a workstation on your network. Starting this
type of remote access requires that you specify the IP address of the
switch in the Telnet protocol.
This method of managing the switch will work only after you have
assigned the switch an IP address and subnet mask or have
implemented the enhanced stacking feature.
SNMP Management
You can also manage a switch with an SNMP management program,
such as HP Openview. This management method requires loading the
AT-8024 and AT-8024GB Fast Ethernet Switch MIBs onto the workstation
from where you intend to manage the switch and that you compile the
MIBs with a MIB complier.
The MIB standards supported by this switch include:
G
G
G
G
G
G
G
Enhanced
This feature is designed to simplify network management. You can use
this feature to manage all the AT-8024GB Fast Ethernet Switches that
Stacking
reside in a subnet on your network from just one management session.
RFC 1213 (MIB II)
RFC 1215 (TRAP MIB)
RFC 1493 (Bridge MIB)
RFC 1643 (Ethernet MIB)
RFC 1573 (Interface Group MIB)
RFC 2674 (IEEE 802.1Q MIB)
Allied Telesyn International (ATI) Enterprise MIB
Note
The MIBs for the AT-8024 and AT-8024GB Fast Ethernet Switches
are available from the Allied Telesyn web site.
Note
This feature applies only to the AT-8024GB switch. This feature is
not supported on the AT-8024 switch.
AT-8024 and AT-8024GB Installation Guide
27