Table of Contents
Advertisement
FIELD INSTALLATION
Mounting a PowerScout
WARNING! Remove the meter from all sources of voltage before mounting.
PowerScout meters must be installed in an approved electrical panel or enclosure using proper
installation practices according to the local electrical codes.
•
To mount the PowerScout 3 Plus use the two tabs provided at both ends of the case. Securely
mount the PowerScout near a dedicated circuit disconnect breaker.
PowerScout 3 mounted within
electrical panel
The raw board of the PowerScout 24 meter can be mounted to customer-provided standoffs or
placed into a NEMA (National Electrical Manufacturers Association) box. A NEMA-rated box is
available through DENT Instruments. Securely mount the PowerScout meter near a dedicated
circuit disconnect breaker.
PowerScout 24 mounted in a NEMA-rated box
near electrical panel
Shop for Dent products online at:
™
Meter
13
PowerMeterStore
www.
Mounting tab, located on each
end of meter case
Standoff mounts (six on bare board)
.com
1.877.766.5412
Advertisement
Table of Contents
