Dent PowerScout 3 Plus Operator's Manual page 98

Modbus
Offset
Register
44401 4400
45200 5199
45201 5200
45202 5201
45203 5202
45204 5203
Shop for Dent products online at:
Register Name
I/O port 2 status
Configures the pulse input for I/O
port 2
I/O port 2 pulse input
accumulator LSW
I/O port 2 pulse input
accumulator MSW
I/O port 2 pulse input scaling
(integer)
I/O port 2 pulse input scaling
(decimal)
Table F-7: Modbus Port 2 Pulse Input
98
PowerMeterStore
www.
Detailed Description
0 = input LOW (switch is closed)
1 = input HIGH (switch is open)
0 = off, pulse input disabled
1 = rising edge, pulse counter increments, falling
edges are ignored. If pulse output is enabled, it is
disabled when this configuration is set.
2 = falling edge, pulse counter increments, rising
edges are irnored. If pulse output is enabled, it is
disabled when this configuration is set.
3 = both edges pulse counter increments. If pulse
output is enabled, it is disabled when this
configuration is set. (Note when pulse is off, I/O
control is enabled)
Setting this register to a value other than 0, forces
register 45210 to 0.
Scaled pulse LSW
Scaled pulse MSW
Integer scale factor
(Scale = 45203 + 45204/1000)
x1000 decimal fraction of scale factor
.com
1.877.766.5412