Using The Starter Control Panel (Motor Rotates); Loading The Project To The Drive Unit - Siemens SINAMICS S120 Getting Started

Using the STARTER Control Panel (Motor Rotates)

4.2

Loading the project to the drive unit

To load the project to the drive unit, proceed as follows:
1. If you have not yet opened "Project_2" (created in Chapter 3) or "Project_1"
(created in Chapter 5) in STARTER, open the project by choosing Project >
Open.
2. To use the "control panel" function, you have to switch to ONLINE mode. To
switch to ONLINE mode, click the function key Connect to target system (as
shown in Fig. 4-1).
Fig. 4-1
3. An ONLINE connection is established and an ONLINE/OFFLINE comparison is
carried out. If any discrepancies are identified, they are displayed (see the
following screenshot).
4-56
2. Click the function key
Connect to target system.
Project navigator with SINAMICS_CU320
SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 03/2006 Edition
 Siemens AG 2006 All rights reserved