Using The Starter Control Panel (Motor Rotates) - Siemens SINAMICS S120 Getting Started

Using the STARTER Control Panel (Motor
Rotates)
This chapter shows you how to start the motor by means of the operator panel
function in the STARTER. The steps for this include:
S Loading the project to the drive unit
S Using the control panel
4.1 Prerequisites
The following prerequisites for using the STARTER control panel must be fulfilled:
S The components are assembled (as described in Chapter 2).
S The device unit has been switched on in accordance with the instructions.
S The PROFIBUS Control Unit interface is connected to a PC/PG with
PROFIBUS interface.
S A project has been created using STARTER.
 Siemens AG 2006 All rights reserved
SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 03/2006 Edition
4
4-55