Entering The Component Topology And Configuring The Drive Unit Automatically - Siemens SINAMICS S120 Getting Started

Creating the Drive Project ONLINE
5.3 Entering the component topology and configuring the
drive unit automatically
Once you have created the project and entered the drive unit with its PROFIBUS
address ONLINE, you have to enter the associated component topology and drive
unit configuration ONLINE.
1. Select the drive unit
Drive_Unit_Adr10.
Fig. 5-6
1. Select the drive unit Drive_Unit_Adr10 in the project navigator.
2. Choose Connect to target system.
3. Select the drive unit Drive_Unit_Adr10 in the project navigator.
4. Choose the Restore factory settings function key (see screenshot below).
Fig. 5-7
5. Confirm the following queries and messages by choosing OK:
– "Restore factory settings?" dialog box
5-72
2. Choose
Connect to target system.
Project_1
Restore factory settings
SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 03/2006 Edition
4. Choose
Restore factory settings.
 Siemens AG 2006 All rights reserved