Siemens SINAMICS S120 Getting Started page 60

Hide thumbs Also See for SINAMICS S120:

Table of Contents

Using the STARTER Control Panel (Motor Rotates)

Fig. 4-6

2. Click Assume control priority to connect the control panel to the drive inter-

face.

Note the message that is then displayed in the Control priority dialog screen.

This message is very important (see also Fig. 4-7).

Danger

Use control priority with care!

The function should be used for commissioning, diagnostics, and maintenance

purposes only.

Make sure that the drive is in the "OFF" status and that no ON/OFF1 command

has been issued either by the control word for sequence control or another signal

source (e.g. BICO interconnection).

Once control priority has been transferred to the PC, the BICO interconnections on

bit 1 to bit 6 of the control word are no longer active.

4-60

Click Assume control priority.

Assuming control priority

SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 03/2006 Edition

Table of Contents