Using The Control Panel - Siemens SINAMICS S120 Getting Started

4.3

Using the control panel

Once you have established a connection with the target system and loaded the
project to the target system, a green plug icon appears in front of the drive unit and
other configured components in the project navigator. This indicates that the project
data in STARTER and the target system is consistent (see Fig. 4-5).
The drive unit is ready to run.
To use the STARTER control panel and start the motor, proceed as follows:
Fig. 4-5
1. Double–click Control panel in the project navigator under Drive_1 > Commis-
sioning (see Fig. 4-5).
The control panel is displayed in STARTER (see Fig. 4-6). You can use the con-
trol panel to control the drive directly from the PC/PG.
 Siemens AG 2006 All rights reserved
SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 03/2006 Edition
Using the STARTER Control Panel (Motor Rotates)
Double-click Control panel in the
project navigator.
Control panel
Green plug icon.
4-59