Adjusting The Print Position - Monarch 9400 Series Operator's Handbook Manual

9400 Series Operator's Handbook
4. Now you can either:
Type I and press
You'll see
Enter a number form 0-144 for the amount of space to
move the cut and press
the cut .052 inches (there are .0052" per dot). The screen
then shows the Print Option menu.
Type D and press
You'll see
Enter a number from 0-144 for the amount of space to
move the cut and press
the Print Option menu.
5. Select another print option, or press
menu.

Adjusting the Print Position

This feature adjusts where the data prints on the supply. It is
only for slight adjustments. For example:
If the data overlaps the preprint on the supply, enter
steps to move the printing down.
If the data is too close to the bottom, enter steps to
move the data up.
5-4
E
to move the cut up.
Amount of Cut increase
[0-144]: 0___(Dots)
E
E
Amount of Cut decrease
[0-144]: 0__(Dots)
E
. For example, 10 moves
to move the cut down.
. The screen then shows
!
to exit to the main