Assigning A Name To The Printer; Using The Chooser To Select Your Printer - Epson STYLUS PRO 5000 Setup Manual

Assigning a name to the printer

Use the following procedure to assign a name to your printer:
1. Double-click the Epson Namer icon.
The Epson Namer utility is located on your hard disk drive
if installed. If it is not installed, insert the printer software
CD-ROM into your computer's CD-ROM drive and open
the utility from there. (If you use the floppy disk version,
insert it in a disk drive and open the utility from there.)
2. Click the SPro 5000(AT) icon in the Device Types window.
3. If there are multiple AppleTalk zones at your site, select the
zone in which the printer is located.
4. Under New Name, enter a name for your printer. You should
assign a name that clearly distinguishes your printer from
others on the network.
5. Click Rename and then click Done to quit Epson Namer.

Using the Chooser to select your printer

After you install the printer software, you need to open the
Chooser to select your printer. You have to choose the printer
only the first time you use it or whenever you want to switch
to another printer. Your Macintosh will always print using the
last printer selected.
If you are using the serial interface, choose your printer driver
as described in the following section, "Using the serial interface
connection." If your system is connected to an AppleTalk
network, see "Using an AppleTalk network" on page 2-33.
2-30
Getting Started