Table of Contents
Advertisement
Installation Instructions
The
Flex
Pro signal booster is suited for installation in a building or home.
Step 1. Connect the Outside Antenna
1.
Mount the fiberglass antenna in an outside mounting location that:
Has at least a 12-inch radius clear of obstructions and other radiating
elements.
Is at least 75 feet in a straight line from the inside antenna when used in an
area prone to weak cellular signals and operating the booster at full 65dB
gain.
Is not co-located or operating with any other antenna or booster.
2.
Using the CM240 or CM400 cable, connect the outside antenna to the booster
connector marked OUTSIDE (see page 4).
3.
Hand tighten the connection.
Step 2. Connect the Inside Antenna
1.
Mount the inside antenna:
Omnidirectional dome antenna: mount the antenna on the ceiling in a
central location where you want reception.
Panel antenna: install the antenna against a wall or surface projecting
where you want reception.
2.
Using the CM240 or CM400 cable, connect the inside antenna to the booster
connector marked INSIDE (see page 4).
3.
Hand tighten the connection.
SureCall Flex Pro Home and Office Kit Cellphone-Mate, Inc.
All rights reserved.
INSTALLATION
Page 6
Advertisement
Table of Contents
Need help?
Do you have a question about the Flex Pro and is the answer not in the manual?