Wireless Local Area Networks; Scanning And Connecting To A Wi-Fi Network - Motorola LEX L10g User Manual

MN002858A01-A
Chapter 8: Wireless
When and where to use: Use this procedure to enable emergency alert messages by cell broadcasts
on the LEX L10g.
Procedure:
1 Tap .
2 Tap .
3 Tap More... .
4 Tap Cell broadcasts.
5 Check the emergency alert types you want to receive.
6 Tap .
8.2

Wireless Local Area Networks

Wireless local area networks (WLANs) allow the LEX L10g to communicate wirelessly inside a
building.
Before using the LEX L10g on a WLAN, the facility must be set up with the required hardware to run
the WLAN (sometimes known as infrastructure). The infrastructure and the LEX L10g must both be
properly configured to enable this communication.
See the documentation provided with the infrastructure (access points (APs), access ports, switches,
Radius servers) for instructions on how to set up the infrastructure.
Once the infrastructure is set up to enforce the chosen WLAN security scheme, use the Wireless &
networks settings to configure the LEX L10g to match the security scheme.
The device supports the following WLAN security options:
• Open
• Wireless Equivalent Privacy (WEP)
• Wi-Fi Protected Access (WPA)/WPA2 Personal (PSK)
• Extensible Authentication Protocol (EAP)
- Protected Extensible Authentication Protocol (PEAP) — with Microsoft Challenge-Handshake
Authentication Protocol version 2 (MSCHAPv2) and Generic Token Card (GTC) authentication.
- EAP-Transport Layer Security (TLS)
- EAP-TTLS - with Password Authentication Protocol (PAP), MSCHAP and MSCHAPv2
authentication
The Status bar displays icons that indicate Wi-Fi network availability and Wi-Fi status.
NOTICE: Turn off Wi-Fi when not using it, to extend the life of the battery.
8.2.1

Scanning and Connecting to a Wi-Fi Network

When and where to use: Use this procedure to scan for and connect to a Wi-Fi network.
Procedure:
1 Tap .
136 Send Feedback