Table of Contents
Advertisement
3.
Afterwards, you can check the configuration by clicking on Run.
If the Run works you can now enter the debug configuration settings.
1.
Open Run -> Debug Configurations....
2.
Select your configuration e.g. LiveSnap mvBL-X and
3.
select in the right window the Debugger tab.
4.
Enter or Browse... the GDB debugger which can be found here:
/usr/local/angstrom/arm/bin/arm-angstrom-linux-gnueabi-gdb
162
mvBlueLYNX-X Technical Manual
Figure 115: Eclipse - Run Configurations
22 April 2016 Version - 1.49
MATRIX VISION GmbH
Advertisement
Table of Contents
Need help?
Do you have a question about the mvBlueLYNX-X and is the answer not in the manual?