Table of Contents
Advertisement
SmartNode 4950-NCE Getting Started Guide
Introduction
The SN4950-NCE model has an option for a built-in G.SHDSL modem. The modem appears in the configu-
ration as "port dsl 0 0" mode.
Profile
napt
WAN
CAUTION
Note
For information about the specifications of the G.SHDSL daughter card,
see Appendix B,
Line Setup
There is no line modulation setting. The modems automatically adapt to the bit rate and modulation used.
The status LED on the back of the device is blinking while the modem attempts to connect and lit when the
link is established. If the modem keeps blinking, check the cabling,
Configuring PPPoE
Figure 8
explains how to configure PPPoE on the SmartNode's built-in G.SHDSL card. To configure the DSL
port for PPPoE, first you need to log in to the SmartNode via the CLI and enter configuration mode.
login: administrator
password: <enter>
SN4xxx>enable
SN4xxx>#configure
Introduction
vpi 8
session MyISP
Figure 8. Configuring the G.SHDSL card for PPPoE
The Modem setup uses IP messages within its own subnet:
192.0.2.0/24. SmartNodes with built-in modems cannot use this
subnet in any other way.
"Specifications"
5 • G.SHDSL Basic Configuration
port
dsl 0 0
\
\
pvc
vci 35
pppoe
WAN
interface
context
ip
on page 46.
Subscriber PPP
MySubscriber
37
Advertisement
Table of Contents
