Attaching The Hotshoe; Closing The Housing - Ikelite 6910.63 Instruction Manual

4. Line the mounting screw up with the camera's tripod socket. Use a
coin or flat head screwdriver to tighten the mounting plate to the
camera.
Mounting screw
5. Pull out on the housing control knobs to move them out of the way.
6. Insert the mounting plate into the slot on the inside bottom of the
housing. Push the camera all of the way forward until the back of
the mounting plate is flush with the back of the housing mount.

Attaching the Hotshoe

1. Make sure the contacts are clean.
2. Slide the hotshoe onto the camera with the LOCK marking towards
the back of the camera.
3. Push the hotshoe forward until it is unable to go any farther. The
hotshoe must be pushed all of the way forward to make proper
contact with the camera and provide TTL operation.
4. Rotate the locking ring clockwise until snug.

Closing the Housing

1. Make sure the o-ring is clean and in its proper location on the back
of the housing. The main o-ring does not require lubricant to make
a seal.
BOTTOM
Camera tripod
socket
1/4-20 thread
FRONT
SIDE
9