Table of Contents
Advertisement
T1/E1 DACS Administrators' Reference Guide
2. Enter the protocol version to be used for sending RIP packets. The following choices are available:
– doNotSend (1)
–
—ripVersion 1 implies sending RIP updates compliant with RFC 1058
ripVersion1 (2)
–
rip1Compatible (3)
sumption rules
–
—ripVersion2 implies multicasting RIP-2 updates
ripVersion2 (4)
3. Enter the protocol version to be used for receiving RIP packets. The following choices are available (note
that rip2 and rip1OrRip2 implies reception of multicast packets.):
–
—ripVersion 1 implies sending RIP updates compliant with RFC 1058
rip1 (1)
–
—rip1Compatible implies broadcasting RIP-2 updates using RFC 1058 route subsumption rules
rip2(2)
– rip1OrRip2(3)
– doNotReceive(4)
4. Click on
Submit Query
Note
Further modifications can be made by clicking on the
2—Configuration").
RIP Version 2—Configuration
RIP Version 2 Configuration
The
Address
named
, displays the RIP IP Address followed by configurable parameters. The configurable parame-
Domain, Authentication Type, Authentication Key, Send, Receive, Metric,
ters are
Address (rip2IfConfAddress)
The IP Address of this system on the indicated subnet. For unnumbered interfaces, the value 0.0.0.N, where
the least significant 24 bits (N) is the ifIndex for the IP Interface in network byte order.
RIP Version 2—Configuration
—rip1Compatible implies broadcasting RIP-2 updates using RFC 1058 route sub-
.
To delete the RIP Address, click on the IP Address under the column
Address
named
. Select Status to be invalid(2) and click on
.
Submit Query
window (see figure 32), seen by clicking on the IP Address under the column
Figure 32. RIP Version 2—Statistics Configuration window
Address
link of the specific subnet (see "RIP Version
13 • RIP Version 2
Status
and
.
85
Advertisement
Table of Contents
