Control Modes; One Shooter (Auto); One Shooter (Sound-Controlled); Multiple Shooters (Master/Slave Control) - SHOWTEC shooter 360 User Manual

Shooter 360

Control Modes

There are 4 modes:

One Shooter (Auto)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Shooter is not connected with a DMX cable, it functions as a stand-alone device.
Please see pages 15 for more information about the Auto mode.

One Shooter (Sound-controlled)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Turn on the music. If the device is set to sound-control, then the Shooter will react to the beat of the
music. Please see page 16 for more information about the sound-control options.

Multiple Shooters (Master/Slave control)

01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Use a 3-pin XLR cable to connect the Shooter.
The pins:
03) Link the units as shown in fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on pages 15 (Auto or Sound-
controlled). This means that you can set your desired operation mode on the master device and all
slave devices will react the same as the master device.
Multiple Shooters (Master/Slave control)
Ordercode: 46001
• Stand-alone (Auto)
• Sound-controlled
• Master/Slave
• DMX-512 (17CH, 33CH)
01) Earth
02) Signal -
03) Signal +
9
Fig. 03