How To Link - FUTABA 3pv-2.4g Instruction Manual

Each transmitter has an individually assigned, unique ID code. In order to start operation,
the receiver must be linked with the ID code of the transmitter with which it is being paired.
Once the link is made, the ID code is stored in the receiver (T-FHSS; and transmitter) and no
further linking is necessary unless the receiver needs to be used with another transmitter. (For
T/R set, the link is already done at factory.)
Link procedure S-FHSS/FHSS (R203GF)
1
Bring the transmitter and the receiver close to
each other, within 20 inches (half meter).
2
Turn on the transmitter and the receiver.
3
Push and hold the Link Switch of the receiver.
4
When the link is complete, the LED in the receiver changes to solid green.
*Please refer to the table below for LED status vs receiver's condition.
LED status vs receiver's condition:
No signal reception
Receiving signals
Receiving signals, but ID is unmatched
Link procedure T-FHSS (R304SB/R314SB)
1
Bring the transmitter and the receiver close to
each other, within 20 inches (half meter).
2
Turn on the transmitter.
3
Select [LINK] and access the setup screen
shown below by pressing the select key [ ▶ ].
Next, press and hold [ ＋ ] or [ － ] key.
4
Turn on the receiver.
5
During countdown, push and hold the receiver tact switch. The LED will begin to blink
red. After the receiver LED switches from blinking red and green → red steady light,
release the tact switch of the receiver. If the receiver LED lights green, linking was
successful. Also check servo operation.
*Please refer to the table below for LED status vs receiver's condition.
LED status vs receiver's condition:
No signal reception
Receiving signals
Unrecoverable failure (EEPROM,etc.)
14

How to Link

LED : OFF
LED: Green ON
LED: Green Blink
LED
■Link Mode
Red : On
Green: On
LED: Red and Green turn on alternately
Link Switch
Link Switch
Press and hold ＋or
－key.
Link mode for 20
seconds.
Blink with Link mode
+
or
*Link is required when a new model
is made from a model selection.
LED
-
Press and hold