FUTABA 3pv-2.4g Instruction Manual page 5

[Range Test Procedure]
Have a friend hold the model, or place it on a stand where the wheels or prop cannot come in
contact with any object. Operate from a distance of about 100 feet. Be sure to check the move-
ment of each servo to make sure it follows the movement of the steering wheel and throttle trig-
ger. If the servos do not follow the commands from the transmitter or any type of interference is
detected, Do Not operate the model.
Never operate in the rain or run through puddles.
The transmitter, receiver, batteries and most servos and speed controls are not waterproof. Con-
tact with any type of moisture or immersion in water or snow will cause damage along with pos-
sible loss of control. Should any type of moisture enter any component of the system, immediately
stop using the R/C system and return it to our service center for inspection.
Do not operate when visibility is limited.
Should you lose sight of the model, a collision or other dangerous situation may occur.
Do not operate near people or roads.
Do not operate on any pond when boats are present.
Do not operate near high tension power lines or communication broadcasting antennas.
Prior to the operation of any model, be sure the area you plan to use is safe. Be aware of all ob-
jects that may be in the path of your model. Do not operate the model where people or any type
of moveable object could stray in the path of your model. Control loss due to interference, compo-
nent failure, loss of sight or low battery voltage could result in serious injury to yourself and others
as well as damage to your model.
Do not operate when you are tired, not feeling well or under the influence of alcohol or drugs.
Your judgment is impaired and could result in a dangerous situation that may cause serious injury
to yourself and others.
(Turning on the power switches)
Always check the throttle trigger on the transmitter to be sure it is at the neutral position.
1. Turn on the transmitter power switch.
2. Turn on the receiver or speed control power switch.
(Turning off the power switches)
Always be sure the engine is not running or the motor is stopped.
1. Turn off the receiver or speed control power switch.
2. Then turn off the transmitter power switch.
If the power switches are turned off in the opposite order the model may unexpectedly run out
of control and cause a very dangerous situation.
Make all adjustments to the radio control system with the engine not running, or the electric motor
disconnected.
If the engine is running or the motor is connected while adjustments are made, the model may run
out of control.
Remove the main battery source from electric powered models when they are not being used.
Should you accidentally leave the receiver switch on, the model could run out of control.
(Fail safe function)
Before running (cruising), check the fail safe function.
Check Method:
Before starting the engine, check the fail safe function as follows:
1. Turn on the transmitter and receiver power switches.
2. Turn off the transmitter power switch.
3. Check if the fail safe function moves the servos to the preset position when reception fails.
The fail safe function is a safety feature that minimizes set damage by moving the servos to a
preset position when reception fails. However, if set to a dangerous position, it has the opposite
effect.
Setting example: Throttle idle or brake position
Do not touch the engine, motor, speed control or any part of the model that will generate heat
while running.
Touching hot parts will result in serious burns.
CAUTION
When the charger is not in use, disconnect it from the outlet. This will prevent accidents, overheat-
ing and short circuits.
5