General Rules; Accident Prevention - Kranzle B170T Operating Manual

General rules

Inspections:
The machine must be inspected according to the „Guidelines for Liquid Spray De-
vices" at least once every 12 months by a qualified person, to ensure that continu-
ed safe operation is guaranteed. The results of the inspection are to be recorded
in writing. This may be done in any form.

Accident prevention

The machine is designed for accidents to be impossible if used correctly. The
operator is to be notified of the risk of injury from hot machine parts and the high
pressure water jet. The „Guidelines for Liquid Spray Devices" must be complied
with. (see page 12 and 13)
Check the oil level at the oil sight glass prior to each use.
(Ensure horizontal position!) The oil level should be at the middle of the sight
glass. With high atmospheric humidity and temperature fluctuation there may be
condensation (oil has a greyish colour); Then the oil must be changed.
Oil change for high-pressure pump B170 T / B200 T
First oil change after approx 50 hours of operation. Thereafter, no more oil change
is required for the lifetime of the equipment. If it becomes necessary during repairs
to perform an oil change, then the oil sight glass should be opened and the oil
emptied into a container. The oil must be caught in a container and disposed of in
a responsible, legal manner.
New oil: 0,3 l - Motor oil W 15/40
Oil change for high-pressure pump B230 T / B240 T / B270 T
The oil of your high pressure pump should be changed after approx. 40 hours of
operation, or no later than when it takes an a grey or whitish colour. Open the oil-
plug over a container and drain off all the oil. The oil must be caught in a contianer
and disposed of in a responsible, legal manner.
New oil: 1,0 l - Castrol Formula RS
Oil leak
In the event of an oil leak contact customer service (dealer) immediately. (damage
to environment or transmission)
19