Stacked ISO DIN radio provision
1. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
2. Attach the factory mounting
brackets and the 95-8202 double
DIN trim plates to the stacked
ISO DIN radios with the screws
supplied with the units. (Figure A)
NOTE: Remove locating
pins from factory brackets
with grinder.
4. Reassemble dash in reverse order
of disassembly.
Kit Assembly 95-8202
Factory
brackets may differ
(Figure A)
17
Notes