Advertisement
The following instructions describe the installation process for a point-
to-point installation. The procedure is similar for compatible HDBaseT
components.
1. Verify all components included with the INT-HD70 extender are
present before installation.
2. If the INT-HD70 extender will be permanently mounted to a surface,
attach the included mounting brackets with the supplied screws.
3. Turn off power and disconnect the audio/video equipment by
following the manufacturer's instructions.
4. Connect shielded, solid core Category 5e or greater twisted pair
cable with RJ45 connectors between the INT-HD70-TX and the INT-
HD70-RX. TIA/EIA-568B straight-through wiring connections must
be used with all HDBaseT extenders.
5. Connect an HDMI cable and any desired control accessories between
the source and the transmitter.
6. Connect an HDMI cable and any desired control accessories between
the display and the receiver.
7. Connect the power supply to either the INT-HD70-TX or the
INT-HD70-RX and lock the power supply to the power connector by
twisting the locking collar clockwise.
8. Power on attached audio/video devices.
Important notice:
•
Do not attempt to disassemble or alter the extender housing. There are no user-serviceable parts inside
the unit. Doing so will void your warranty.
•
To minimize the possibility of equipment damage from electrostatic discharge (ESD), all source and
destination equipment must be powered off during installation.
•
Do not connect the extender to a telecommunication outlet wired to unrelated equipment. Doing so may
damage the unit or any connected equipment. Ensure all connected twisted pair cabling is straight-through
(point-to-point).
•
Allow proper ventilation to reduce the risk of thermal failure.
Installation Instructions
Advertisement
