Page 1
HDCP INT-HD70-RX HDCP The Intelix INT-HD70 extends HDMI, IR, and RS232 over a single solid core shielded Category 5e or greater cable using the Valens VS010TX HDBaseT chip. The INT-HD70 supports a 1080p video signal, including HDCP 2.2 and multichannel audio, up to 70m, as well as 3D and 4K x 2K (UHD) signals up to 40m.
1. Verify all components included with the INT-HD70 extender are present before installation. 2. If the INT-HD70 extender will be permanently mounted to a surface, attach the included mounting brackets with the supplied screws. 3. Turn off power and disconnect the audio/video equipment by following the manufacturer’s instructions.
Page 3
3-pole Removable Terminal Block • Installation Guide INT-HD70-TX or Controller or RS232 Wiring INT-HD70-RX Device Connect the controller or device RXD signal to TX on the INT-HD70 extender. Connect the controller or device TXD signal to RX on the INT-HD70 extender.
Page 4
Diagnostic Indicators HDCP, Link, and Power Included Accessories Installation Guide, power pupply, 3-pin removable screw terminal, mounting brackets with screws Intelix is a brand of Liberty AV Solutions. 11675 Ridgeline Dr. Colorado Springs, CO 80921 Toll-Free: 800-530-8998 Fax: 719-260-0075 www.libav.com...
Need help?
Do you have a question about the int-hd70 and is the answer not in the manual?
Questions and answers